Santec 3061MU - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the trim parts off the box.
Place the trim parts against the assigned wall location.
Make sure that the bar is leveled and the bar post positions are correct.
Mark the bar post flange positions and remove the trims.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware posts can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware posts by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the bar posts’ set screws
Slip the left bar post onto the left mounting hardware post.
Align the bar post and secure it by tightening the set screw.
4- Insert the towel bar into the secured bar post.
Slip the right bar post onto the right mounting hardware post.
Insert the right side of the towel bar into the right bar post.
Align the right bar post and tighten the set screw firmly.
5- Check both bar posts to make sure they are firmly secured.
If not, tighten the set screws with the Allen key.
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
WALL
3061MU _ _