Santec 2681EK - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
EXTENDED SINGLE CONTROL LAV SET
COLLECTION
S POUT I NSTALLATION
Step 1
· Remove lock nut, metal washer
and rubber washer from mounting
rods.
Step 3
· Reinstall rubber gasket and metal
washer from below.
· Hand tighten lock nut from below
while aligning fixture.
Step 2
· Apply a ring of silicone caulking
around hole designated for spout.
DO NOT USE PLUMBERS’ PUTTY
WHICH CAN DAMAGE FINISH.
· Insert faucet assembly through
hole in sink or counter top, being
sure to center faucet in hole.
Step 4
· Secure fixture from below by using
either an adjustable wrench, basin
wrench or deep socket to the lock
nut.
· Connect fixture to water supplies.
NOTE.
Before opening supply valves, remove aerator! Slowly open water supplies to flush fixture of any debris and
reinstall aerator prior to using fixture. Debris present in the line will damage fixture and case leaking. Failure to
flush fixture could result in possibly voiding warranty.
rubber washer
metal washer
lock nut
SIL
IC
ON
E