Santec 2670EZ - Manual (Page 3)

INSTALLATION INSTRUCTIONS
PAGE 03
POP-UP INSTALLATION
- Remove decorative drain flange and drain plug from pop-up assembly.
- Apply a ring of silicone caulking to underside of decorative drain flange.
DO NOT USE PLUMBERS' PUTTY, WHICH CAN DAMAGE FINISH.
- Insert threaded end of the assembly up from below bidet.
Completely thread drain body into decorative drain flange and align with ball rod hole
facing back and tighten lock nut from below.
- Insert drain plug into decorative drain flange with adjustable eye-screw facing back.
Attach ball rod washers and ball rod nut to horizontal ball rod and install into drain
body. Do not over tighten, ball rod must operate freely.
- Drop lift knob flange through appropriate hole in bidet and attach mounting hardware.
Insert lift rod and knob through lift knob flange, lift rod strap and tighten thumbscrew.
- Gently push the horizontal ball rod down to place the drain plug in the up position.
- Slip one leg of ball rod clip off horizontal ball rod and insert lift rod strap, reattach leg
of ball rod clip.
- Test pop-up for smooth operation and adjust if necessary.
INLET HOSE INLET HOSE
SANTEC SANTEC
INLET HOSE INLET HOSE
SA NTE C SA NTE C
Drain Flange
Lift Rod Strap
Ball Rod
Drain Tube
Ball Rod Nut
Ball Rod Clip
Thumb Screw
Lock Nut
Washer
Gasket
Side hole
Rubber Washer
Metal Washer
Lock Nut
Lift Knob Flange
Flange Shank
Lift Rod
Lift Knob
FLUSH THE LINE
- After all connections have been made from inlet supplies to angle stops, remove the
spritzer housing, basket and washer.
- Open both hot and cold valves. Slowly open angle stops from below and flush the lines
for approximately 45 seconds to clear any debris.
- Turn water off and reinstall spritzer housing, basket and washer.