Santec 2566XU - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the robe hook off the box.
Place the robe hook against the assigned wall location.
Mark the robe hook flange position and remove the trim.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware post can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware post by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the robe hook’s set screw.
Slip the robe hook with the washer onto the mounting hardware post
and tighten the set screw.
4- Check the robe hook to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
2566XU _ _