Santec 2546YC - Manual (Page 3)

SIDE SPRAY INSTALLATION
1
- Slip the guide tube (18) and flange (17) and the washer down from the top of the tub
through the appropriate hole. Slip the mounting hardware (16) from the bottom of the
tub, first the crimped metal washer then the brass lock nut. Tighten the lock nut firmly.
2
- Slip the hose through the guide tube (18) from the top of the counter.
- Connect the coupler to the side spray.
- Connect the other threaded end of the hose to the diverter tee connector (12).
Tighten to avoid leakage.
WATER TEST
- Turn on the cold water supply.
- Use the handle from the faucet set to turn the valve on and off.
- Check for leaks. If water leaks from any of the connections merely tighten the
connections until the leak stops.
- Repeat the same procedure for the hot side.
- With the water fully opened, press the side spray trigger to make sure that the water is
diverting from the spout to the side spray.
SANTEC SANTEC
INLET HOSE INLET HOSE
TO THE COLD SUPPLY LINE
Metal washer
Brass lock nut
Plastic washer
Diverter
SANTEC SANTEC
INLET HOSE INLET HOSE
TO THE HOT SUPPLY LINE
Diverter
PAGE 03
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com 03/03
INSTALLATION INSTRUCTIONS
2546YC _ _