Santec 2534XA - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle flange onto the handle bell.
- Screw the handle bell with handle flange and washer onto the all
thread. Press them firmly against the plate and mark the position.
Cut off the excess thread. Reinsert the handle trim onto the all thread.
- Insert the handle onto the stem. Measure the excess between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Using the Allen Key provided,
tighten the handle set screw firmly.
- Place the Trim Plate Grommet onto the designated hole for the
Diverter Rod on the Trim Plate.
- Screw the Diverter Knob onto the Diverter Rod.
H H
C C
INSTALLATION INSTRUCTIONS
2534XA _ _
All Thread
Lock Nut
Lock Plate
S
T
Diverter Rod
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE
Trim Plate
Diverter Knob
Trim Plate Grommet
Stem
S
T
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C