Santec 2532XA - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle flange onto the handle bell.
- Screw the handle bell with handle flange and washer onto the
all thread. Press them firmly against the plate and mark the position.
Remove the trim and cut off the excess thread.
- Insert the handle onto the stem. Measure the excess between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Tighten the handle set screw
firmly using the Allen Key.
H H
C C
INSTALLATION INSTRUCTIONS
2532XA _ _
All Thread
Lock Nut
Lock Plate
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE
Trim Plate
Stem
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN