Santec 2220LM - Manual (Page 3)

3
- Loop and connect the flexible hoses (8) to the tee (10). Tighten to avoid leakage.
- Connect and tighten the Inlet hoses (9) to the supply lines.
- After the connections have been made, turn on the water supply and check for
leakages at all joints. If water leaks from any of the connections tighten the
connection until the leakage stops.
- If no leakage, turn the handles to the full open position and let the water flush for
45 second. This can prevent damages to the ceramic cartridges caused by debris
in the supply line.
-.During the flushing, check for leakage at the connecting joints and repeat step 3 if
necessary.
INSTALLATION INSTRUCTIONS
Water supply
line
SANTEC SANTEC
INLET HOSE INLET HOSE
SANTEC SANTEC
INLET HOSE INLET HOSE
SANTEC SANTEC
INLET HOSE INLET HOSE
TO THE COLD SUPPLY LINE TO THE HOT SUPPLY LINE
PAGE 03
2220LM _ _