Santec 2034XL - Manual (Page 3)

TRIM INSTALLATION
- Place the trim plate grommet onto the designated hole for the
diverter rod on the trim plate.
- Screw the diverter knob onto the diverter rod.
- Place the shower plate on the all thread..
- Screw the handle flange, washer and bell onto the all thread and
press it firmly against the plate. Mark the position of the handle bell
on the all thread. Take off the handle bell and cut off the excess
thread. Reinsert the handle bell onto the all thread.
- Insert the handle onto the stem. Measure the excess stem between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Insert the screw and tighten it firmly.
- Insert the porcelain button and screw the handle cap onto
the handle and tighten it firmly. Make sure that the handle body turns
freely in both directions without scraping against the handle flange.
H H
C C
INSTALLATION INSTRUCTIONS
All Thread
Lock Nut
Lock Plate
S
T
Diverter Rod
Trim Plate
Diverter Knob
Trim Plate Grommet
Stem
S
T
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE SCREW BUTTON CAP
2034XL _ _