Santec 2034LV - Manual (Page 3)

TRIM INSTALLATION
- Place the Trim Plate Grommet onto the designated hole for the
Diverter Rod on the Trim Plate.
- Screw the Diverter Knob onto the Diverter Rod.
- Place the shower plate onto the all thread.
- Screw the handle flange with the washer onto the all thread, press
it firmly against the plate.
- Insert the handle body onto the stem. Measure the gap between the end
of the handle body and the handle flange. Take the handle body off and
cut off the excess thread and stem.
- Re-insert the handle body onto the stem and secure its screw firmly with
the Allen key provided.
- Make sure that the handle body turns freely in both directions without
scraping against the handle flange.
H H
C C
INSTALLATION INSTRUCTIONS
All Thread
Lock Nut
Lock Plate
S
T
Diverter Rod
Trim Plate
Diverter Knob
Trim Plate Grommet
Stem
S
T
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
HANDLE FLANGE HANDLE BODY FLANGE WASHER
2034LV _ _