Santec 2029LV - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”
INSTALLATION INSTRUCTION
INSTALLING THE VALVE WITHOUT THE TRIM
1- If the valve is installed first without the trim, please leave
3 ½” ~ 4 5/8 ” space between the center of the inlet and the
finished wall. This will leave enough thread length to be
adjusted when the trim is installed.
WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.
INSTALLING THE VALVE WITH THE TRIM
1- Install the valve onto the wall with 2-1/2” space
between the center of the valve inlet and the
finished wall.
2- Screw the handle flange with the washer onto
the all thread, press them firmly against the wall.
PAGE 02
center of IN port
FLANGE WASHER
finished wall
3 ½” ~ 4 5/8 ”
HANDLE FLANGE HANDLE BODY
ALL THREAD
STEM
ALL THREAD
STEM
2029LV _ _