Santec 1455DD - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM IS 1 1/2 ”
SPOUT INSTALLATION
2.
- Remove the faucet from the box.
- From the top of the deck, slip the spout with the flange (1 and 2) onto the quick connect shank.
Align the spout and tighten the set screw firmly using the large Allen key (21).
3
- Connect the spout shank to one of the outlet port (OUT) of the diverter valve after the diverter
valve is installed. **
Note: for better installation it is advisable to place silicone caulking around all holes on the top
of the deck
If the trim is ordered separately, please keep the shank protector on the quick connect shank
at all time to avoid damages to the unit.
HANDLE INSTALLATION
1.
- Remove the pre-assembled handle trim (3) and top lock nut and washer (5) from the valve body.
Use the medium Allen Key (22) to loosen the handle top. For proper turning direction, the cold valve (9)
should be installed on the right side and hot valve (8) on the left side looking from the front.
- Slip the valve body (8) or (9) with the lower lock nut and washer (5) up from the bottom of the tub
through the appropriate hole next to the spout. From tub top, screw the top washer and lock nut (5)
and handle trim (3) back onto the valve body. Adjust the top lock nut to make sure that the handle
trim sits flushed against the tub surface.
2
- Position the valve body side outlet towards the diverter valve (12) for easier pipe connection.
Align the handle lever and tighten the lower lock nut (5) firmly. Make sure that the handle turns
freely in both directions. Tighten the handle top using the medium Allen key (22).
Repeat the same procedure for the opposite side.
- Connect the water supply to tines to the bottom inlets of the valve bodies. **
- Connect the valve body side outlet to the inlet (IN) of the diverter valve (12) after the diverter
is installed. **
1
- Remove the Quick Connect Spout Shank and Mounting Hardware from the box.
Remove the mounting hardware (metal washer and brass lock nut) from the Quick Connect
Shank.
- From the top of the deck, slip the quick Connect shank through the assigned spout hole.
- Secure the quick connect shank by putting the washer and locknut back on the shank.
Tighten the lock nut firmly.
Lower Fiber washer
Lower Brass lock nut
Medium Allen Key
Handle Top
Handle Bell
Handle Flange
Top Lock Nut
Top Fiber Washer
1455DD _ _
PAGE 02
Metal washer
Brass lock nut
Metal washer
Brass lock nut
Flange washer
Large Allen Key