Santec 1434RP - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle flange with the washer onto the all thread, press it
firmly against the plate.
- Insert the handle base onto the stem. Measure the gap between the end
of the handle base and the handle flange. Take the handle base off and
cut off the excess thread and stem.
- Reinsert the handle base onto the stem and secure it with the screw.
.Tighten it firmly. Screw the handle ring onto the handle base.
- Screw the cap onto the handle base and tighten it firmly.
- Make sure that the handle base turns freely in both direction without
scraping against the handle flange.
- Place the trim plate grommet onto the designated hole for the
diverter rod on the trim plate.
- Screw the diverter knob onto the diverter rod.
H H
C C
INSTALLATION INSTRUCTIONS
All Thread
Lock Nut
Lock Plate
S
T
Diverter Rod
Trim Plate
Diverter Knob
Plate Grommet
Stem
S
T
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
HANDLE FLANGE HANDLE BASE HANDLE RING CAP FLANGE WASHER SCREW
1434RP _ _