Santec 1434LM - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle flange with the adapter onto the handle bell.
- Screw the handle bell with handle flange and washer onto the all
thread, make sure the flange and washer are firmly flushed against
the plate. Mark the position, remove the handle trim and cut off the
excess thread. Reinsert the handle bell, flange, washer and adapter
onto the all thread. Make sure the flange and washer are firmly
pressed against the plate.
- Insert the handle onto the stem. Measure the excess between the
handle bell and the handle. Take off the handle and cut the excess stem.
- Reinsert the handle onto the stem. Tighten the handle set screw firmly
using the Allen Key.
- Place the trim plate grommet onto the designated hole for the
diverter rod on the trim plate.
- Screw the diverter knob onto the diverter rod.
H H
C C
INSTALLATION INSTRUCTIONS
1434LM _ _
All Thread
Lock Nut
Lock Plate
S
T
Diverter Rod
Trim Plate
Diverter Knob
Plate Grommet
Stem
S
T
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE FLANGE ADAPTER