Santec 1432LM - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate onto the all thread.
- Screw the handle flange onto the handle bell and tighten it firmly.
- Screw the handle bell with handle flange, washer and adapter onto
the all thread, make sure the flange and washer are firmly flushed
against the plate Mark the position, remove the handle trim from the
all thread and cut off the excess thread.
Reinsert the handle bell, flange, washer and adapter onto the all
thread. Make sure the flange and washer are firmly pressed
against the plate.
- Insert the handle onto the stem. Measure the excess between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Tighten the handle set screw
firmly using the Allen Key.
H H
C C
INSTALLATION INSTRUCTIONS
1432LM _ _
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE
Stem
All Thread
Lock Nut
Lock Plate
Trim Plate
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN
FLANGE ADAPTER