Installation instructions, Illustration c, Trim installation – Santec 1334AA User Manual
Page 3
TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle bell and flange onto the all thread, make sure that
both parts are flushed firmly against the plate. Mark the position and
remove the handle bell and flange and cut off the excess thread.
Re-insert the handle bell and flange onto the all thread.
- Insert the handle onto the stem. Measure the excess between the handle
bell and the handle. Take off the handle and cut the excess stem.
- Reinsert the handle onto the stem. Using the Allen key provided, tighten the
handle set screw firmly.
- Place the Trim Plate Grommet onto the designated hole for the
Diverter Rod on the Trim Plate.
- Screw the Diverter Knob onto the Diverter Rod.
INSTALLATION INSTRUCTIONS
All Thread
Lock Nut
Lock Plate
S
T
Diverter Rod
Trim Plate
Diverter Knob
Plate Grommet
Stem
S
T
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
ILLUSTRATION C
HANDLE FLANGE
HANDLE BELL
HANDLE
COLD
WARM
WARMER
HOT
C
C
H
H
C
C
H
H
1334AA _ _