Sandia Aerospace SAE 5-35 Installation Manual User Manual

Page 13

J4 Notes:

1. J4 is 15 Pin receptacle
2. Pin 6 may be strobed or permanently grounded.

Pin 6 must be grounded for AIM function to
be operational.

3. Power and ground wires (pins 8, 14 & 15) are

20 AWG. All other wires are 22AWG unless
otherwise noted.

4. Pin 8 and 14 are internally connected in the

SAE5-35. Only one line is necessary to supply
power to the unit. The unused power pin may
be used as a power loss indicator if desired.

5. The Garmin 430/530 must be set to Icarus

RS232 format.

J5 Notes:

1. J5 is 9 Pin receptacle
2. Maximum lamp current 80mA
3. All wires are 22AWG unless otherwise

noted.

4. AIM switch is a momentary contact
5. Ground pin 4 for 1200 baud

Leave pin 4 open for 9600 baud (see
Paragraph 1.2.6.1 & 1.2.6.2 for details).

6. If the AIM function uses annunciator

lamps provided by the installer, they
should be appropriately labeled. The
lamp connected to pin 9 should be
labeled ‘ALT’ and the lamp connected
to pin 8 should be labeled ‘SET’.

Figure 3-4

J4 Pinout

Figure 3-5

J5 Pinout

305186-00