Sandia Aerospace AIS200A-35 User Manual

Page 6

SECTION 3

INSTALLATION PROCEDURES

3.1

General
The AIS 200-35 and AIS 200A-35 is supplied with a 78 pin Sub D mounting connector and 80 crimp
style contacts. The AIS 200-35 and AIS 200A-35 is hard mounted in any axis using four (4) number 6
or 8 screws.

3.2

Equipment Required

3.2.1 Supplied

Model AIS 200-35, Sandia Part Number AIS 200-35 or Model AIS 200A-35, Sandia Part Number
306119-00
Electrical Installation Kit Sandia Part Number 305552-00. The installer may also use the manufac-

tures part in lieu of the Sandia Part. The Manufacturer and their part number is listed below along
with the Sandia Part Numbers.

1 each

204508-1 Connector Housing (AMP/TYCO P/N 204508-1)

1 each

305055 Connector Clamp (AMP/TYCO 1-5207908-3)

80 each

305070 Crimp Contacts (AMP/TYCO P/N 204351-1)

3.2.2 Required But Not Supplied

Four (4) Number 6 or Number 8 or equivalent mounting screws.

3.3

Mounting

The AIS 200-35 and AIS 200A-35 mount with four (4) Number 6, 8 or equivalent machine screws in the
four holes in the units mounting ﬂ anges.

Figure 3-1

Mounting Dimensions

306147 Rev A