Cleaning furniture – Reliable E40 User Manual
Page 24
22
Run the cloth evenly on the surface without
pushing down on it. Repeat on heavily soiled
areas. In case of ceramic floor, use the
brush without cloth to remove persistent
dirt. Always wipe the surface with a clean dry
cloth to remove the soiled steam residue.
Wax removal from ceramic floors:
Use the brush without cloth; then wipe
away the soiled steam residue with a clean
dry cloth.
Other large surfaces:
Use the triangular brush 26 or the
rectangular brush 21 with or without
extension wand.
This set is recommended for:
t
8BMMTUJMFT
t
#MJOET TIVUUFST SPMMJOHTIVUUFST
To clean these surfaces, please refer to the
instructions above.
CAUTION
ATTENTION
IMPORTANT
When cleaning vertical surfaces, always
remember that steam dissolves the dirt which
runs downward. Therefore, it is necessary to
be prepared to collect the dissolved dirt using
a clean dry cloth.
CAUTION
ATTENTION
IMPORTANT
With extended use or excessive pressure, the
brush bristles could pierce the cloth cover
and scratch the treated surface. Do not exert
undue pressure and regularly check that the
bristles are not poking through the cloth.
Correct cleaning depends on the steam
power rather than on the pressure exerted on
the brush.
CAUTION
ATTENTION
IMPORTANT
When cleaning delicate surfaces or hand-
painted tiles, always mount the cloth on the
brush. Always carry out a preliminary test by
spraying the steam on a small less visible
area of the surface and check the results
once dry.
CLEANING FURNITURE
Recommended accessories:
26 Triangular brush
Always mount the cloth supplied on the
triangular brush 26 and set the variable
steam control to an intermediate position
NJOJNVNGPSPSEJOBSZDMFBOJOHPSEFMJDBUF
surfaces like antique, lacquered or
upholstered pieces of furniture; maximum: to
remove grease stains from kitchen elements
PSSFTJTUBOUQMBTUJDMBNJOBUFGVSOJUVSF
Run the cloth evenly on the whole surface
without pushing down on it. Repeat on
heavily soiled areas. If necessary, increase
the steam flow. Always, wipe the treated
surface with a clean dry cloth after cleaning.
64&