Crestron electronic Four-Way Coupler SRD-CPL-4 - Manual (Page 8)

Four-Way Coupler Crestron SRD-CPL-4
Industry Compliance
As of the date of manufacture, the SRD-CPL-4 has been tested and found
to comply with specifications for CE marking and standards per EMC
and Radiocommunications Compliance Labelling.
Installation
Installation of the SRD-CPL-4 coupler consists of the following. Refer
also to the block diagram on page 2.
Attach the RG-6 cable from the antenna to the port labeled IN on
the coupler. •
NOTE: For best results in all configurations, use quad-shielded RG-6
cable whenever possible.
• Attach an F-male to F-male 12-inch cable between one of the
coupler OUT ports and the IN port of one of the SRD-SPL-4
splitters.
4 • Four-Way Coupler: SRD-CPL-4 Installation Guide – DOC. 6725A