PYRAMIDA N 60 - Manual (Page 28)

EN
28
Single-phase network, to which the
product is connected, has to correspond
to the acting roles. Connection has to
be done via automatic circuit-breaker, built-in to the fixed
wiring on your electric service panel. All actions related to
the connection, adjustment, maintenance and repair of the
device, and retubing are to be done without line voltage! For
this you need to switch off the electric switch on your panel or
drag out the plug from the socket. Do not pull the plug wire!
Do not pinch or strain network cable.
Extenders and adapters use is forbidden. Manufacturer
of extractor fan does not respond for breakdowns or
inflammations arisen as a result of T-bends or extenders
use. To replace damaged network cable call specialist from
a service center.
Before installation it is necessary to be sure that there are
no visible damages of the propeller, extractor fan case, and
also there are no foreign objects in the flowing part of the
case, that can damage propeller blades. If you doubt that the
fan is intact and complete, call the seller immediately.
It is forbidden to misuse the device, modify it or update.
Product is not intended to be used by children and persons
with reduced physical, sensory or mental abilities or if they
don’t have any experience in using extractor fans, unless
they are under control or have been instructed by the person
responsible for their safety. Children have to be under control
of adults for avoiding of games with the device.
Pumped air cannot contain dust and other solid impurities,
and also sticky substances or fibrous materials. It is forbidden
to use the product with present inflammable substances and
their fume, such as spirit, benzine, insecticides, etc.
Do not shut or bar suction and discharge port of the device,
not to prevent optimal passing of the air. Don’t reduce
diameter of the air duct to less than 150 mm.
Do not sit down on the product and don’t put any objects
on it.
Under the extractor fan one cannot cook such dishes
as flamb é (dishes that are poured with alcohol and set
on fire). Watch that during cooking there is no oil ignition.
Remember that repeated use of oil increases probability of
its autoignition.
Do not leave the fan in use unattended for a long time.
After the fan has been in use for a long time don’t touch the
backlights – they are hot. While replacement of lamps it is
necessary to disconnect the device from electric network.
Don’t touch the fan surface with wet hands.
OPERATION SAFETY REQUIREMENTS