PULSE ShowerSpas 1025 Paradise - Manual (Page 5)

5
Assembly
After unpacking your ShowerSpa, some assembly is required prior to installation.
Shower Arm Assembly
1. On the back of the ShowerSpa near the top, unscrew the hose fitting from the safety insert (19) and retain rubber washer. Remove the
safety insert and discard with plastic nut (18).
2. Place escutcheon (2) over threaded end of shower arm (3) and insert through opening. Use stainless nut (6) to secure shower arm to Show-
erSpa. Then secure both set screws (10) located on the stainless nut.
3. Attach hose fitting to shower arm (3) ensuring the rubber washer is still in hose fitting. Do not over-tighten.
Hand Shower Holder Assembly
NOTE— The hand shower holder (11) is directional and must be installed so the set screw (4) is facing down in order for the tapered end of the
hose to fit properly.
1. Use 4mm allen wrench to remove allen bolt (12) from hand shower holder (11) and retain lock washer (13). Insert bolt through lock washer,
then opening on side of ShowerSpa. Tighten bolt to holder while adjusting its’ position (we recommend a slight forward angle).
2. Secure set screw (10) on bottom side of holder to lock in place.
After ShowerSpa is mounted to the wall
Hand Shower Assembly
1. Insert washer (7) into hexagon shaped end of hand shower hose (8) and attach to threaded outlet on bottom of ShowerSpa. Do not over-
tighten.
2. Insert washer (7) into tapered end of hand shower hose (8) and attach to hand shower (9). Insert hand shower into hanger.
3. Check that rubber screen washer (4) is in shower head (5) and screw shower head onto the shower arm (3).