PULSE ShowerSpas 1035 Oahu - Manual (Page 5)

5
Assembly
After Unpacking Your ShowerSpa, Some Assembly Is Required Prior To Installation
Hand Shower Holder Assembly
Figure A
1. Place the threaded end (on main axis) of the hand shower holder (5) into the hand shower outlet (7). Make certain the threads for the
hand shower hose are pointing down. Refer to diagram for proper positioning.
2. Tighten hand shower holder (5) to ShowerSpa (1) with nut (6).
3. Check the open end of the hose on back of ShowerSpa for a rubber washer (17). If no washer is present, place one into the hose. Tighten
hose to the hand shower holder (5) making sure there are no kinks in the hose. DO NOT OVERTIGHTEN.
4. Check connection for leaks after supply lines are connected.
Showerhead Assembly
Figure B & C
1. Align the four mounting holes of the showerhead with the holes in the top of the ShowerSpa panel.
2. Refer to the diagram for proper placement of bolts (13), washers (12), lock washers (11) and nuts (10). Secure the showerhead to the panel
with supplied allen wrench (9). Make certain the connection is tight and there is no "play" between the two items.
3. Route hoses from inside ShowerSpa (1) through the holes in back of showerhead (2). Connect hoses to the showerhead fittings making sure
there are no kinks in the hoses. DO NOT OVERTIGHTEN.
4. After the unit is installed, check these connections to ensure there are no leaks.
5. Slide cover (8) into the top of the showerhead (2) with the finger hole towards the back side.
After ShowerSpa Is Mounted To The Wall
Connect The Hand Shower
1. Insert a rubber washer (17) into the hex end of the shower hose (4), and attach to the hand shower holder (5).
2. Insert a rubber washer (17) into the tapered end of the shower hose (4) and attach to the hand shower (3). Place the tapered end of the
hose into the hand shower holder (5).