Calibrating the sensors – Proto-X Proto-X User Manual

Page 2

HOW TO FLY

CORRECTING DRIFT

LANDING SAFELY

TROUBLESHOOTING

REPLACEMENT BLADES

It is normal for the quadcopter to drift slightly. However if it drifts
in any direction consistently press the trim button opposite the
movement as many times a needed to eliminate the drift.

FORWARD

DOWN

ROTATE LEFT

LEFT

LEFT TRIM

FORWARD TRIM

LEFT TRIM

ROTATE RIGHT

RIGHT

RIGHT TRIM

FRONT

Gray Blades, Blue LEDs

REAR

Black Blades, Red LEDs

BACKWARD TRIM

RIGHT TRIM

BACKWARD

DOWN

When the battery voltage begins to run low, the LEDs will begin
to fl ash. It is time to land before the built in low voltage cut off
reduces power to the motors.

PROBLEM: Controller cannot be linked to the quadcopter.
SOLUTION: Throttle position needs to be at zero.

PROBLEM: Controller LED fl ashing after binding.
SOLUTION: Replace batteries.

PROBLEM: Quadcopter shaking.
SOLUTION: Check if the canopy, chassis and rotors are damaged.

PROBLEM: Will not take off.
SOLUTION: Check that the rotor blades are properly installed.

CALIBRATING THE SENSORS

If the quadcopter doesn’t trim well,

recalibrate the sensors.

1. Turn on the controller and the quadcopter. Place the quadcopter on a

fl at surface.

2. Hold the left stick to the lower right. At the same time, quickly move the

right stick left and right several times until the blue LED’s fl ash.

protoquad.com