Centro 03122008 EJ User Manual

Page 10

Match-Lighting Main Burners

1. Open lid. Turn off all control knobs. Ensure LP cylinder is closed.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas

supply valve.

3. Insert a lit match or a butane lighter into the match lighting hole located on

the left hand side or right hand side of the barbecue cart (on the under side
of the burner side shelf ).

4. Turn the selected burner control knob, either the far right or far left, to the

HIGH position. Be sure the burner lights and stays lit.

5. Light adjacent burners in sequence by pushing knobs in and turning to “HI”.

Lighting the SIDE BURNER (if applicable)

1. Open side burner lid. Confirm that all burner control knobs are in the OFF position before opening the gas supply.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas supply valve.
3. Turn the burner control knob to the “HI” position.
4. Immediately activate the Igniter. The selected burner should light within five seconds.
5. If ignition does NOT occur in 5 seconds, turn the burner control OFF, wait 5 minutes for the gas to clear and repeat the

lighting procedure.

6. If the burner will not light when using the ignitor, follow the match

lighting instructions.

WARNING

Do not lean over grill while lighting.

Match lighting the SIDE BURNER (if applicable)

1. Open lid. Turn OFF all control knobs. Ensure LP cylinder is closed.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas

supply valve.

3. Insert a lit match or a butane lighter under the side burner grate.
4. Turn the side burner control knob to the “HI” position. Be sure the burner lights

and stays lit.

CAUTION

If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the

lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of

the burner and could accidentally ignite with risk of injury. Turn controls and gas source OFF when

not in use.

WARNING:

Never operate main BBQ burners in conjunction with the Rotisserie burner, as this may result in

overheating your BBQ, fire, explosion, personal injury or property damage.

Lighting the ROTISSERIE BURNER (if applicable)

1. Open BBQ lid. Ensure all control knobs in the OFF position before opening the gas supply.
2. Turn on the gas supply valve at the tank (1 to 2 turns) or turn on the main gas supply valve.
3. Turn the Rotisserie burner knob to the “HI” position.
4. Press and hold ELECTRONIC IGNITER button.
5. If the Rotisserie burner does NOT light, turn knob to OFF, wait 5 minutes, and then

repeat lighting procedure.

6. If the Rotisserie burner still does not light follow the match lighting procedure for the Rotisserie burner.

Model may not be exactly as shown.