PRG Vx76 Basic Profile Editor User Manual v1.1 - Manual (Page 8)

6 VX76 BASIC PROFILE EDITOR USER MANUAL
Icon
26 List specifying the icon used to represent the fixture in the Planview.
3D
27 Information related to the representation of the fixture in the 3D Graphic window.
Draw Distance
The distance, in feet, that the fixture's beam should render. Set this to a small number for LEDs used in an array
for a short-throw projecting effect.
Zoom Ratio
Ratio of the fixture's Zoom parameter. Expressed as a ratio, e.g., 8:1.
Beam Range
Degree range of the fixtures' Beam parameter from lowest to highest. If the fixture has no beam iris, set both
numbers to the fixture's lens angle.
Pan/Tilt Travel
Degree travel of the Pan and Tilt parameters, if applicable.
Pan/Tilt Orthog
The DMX value of Pan and Tilt parameters when the fixture is in its 50/50 position.
Model
List specifying the model used to represent the fixture in the 3D Graphic window.
Fixture Control
28 Contains the macro lists associated with the Lamp Start, Lamp Douse, and Fixture Reset functions available from
the console. Use these sections to create complex macros necessary to remotely strike, douse, and reset the
fixture over DMX. This often requires a number of values to be held for a period of time before the function will
execute on the fixture.
Add Event
29 Adds a DMX event to the end of the macro list.
Add Delay
30 Adds a Delay event to the end of the macro list.
Remove
31 Removes the selected event or delay from the macro list.
Event Channel
32 Sets the DMX channel that the value will be sent to.
Value
33 Sets the value to be sent to the DMX channel for events, or the number of seconds to delay before taking the next
event for a delay.
Note
34 Field for adding any pertinent information about the profile to be displayed when inspecting in the console's
fixture type picker.