phil&teds tott v1 - Manual (Page 3)

16. It is most important that the seat belt is correctly routed and the child seat tightened down on the
upholstery as firmly as possible to ensure maximum protection – a recommended method is
shown in these instructions.
17. Never use this product if it has been in an accident, or if it has become badly worn. Periodically
inspect the harness for wear, paying particular attention to attachment points, stitching and
adjusting devices.
18. Ensure that no part of the seat or seat belt is trapped in a door or a folding seat. If your car has a
folding rear seat, ensure that it is correctly latched in its upright position.
19. The child seat must not be used without the cover.
Instructions for fitting & use
shoulder strap
Before installing the tott into a car, always check that the shoulder straps are at the correct height for your
child. The child’s shoulders should always be below the slot for the harness.
adjusting the shoulder strap height:
Release the strap holding the backrest cover to gain access to the harness. Slide one of the harness
straps off the harness connector. From the front of the seat, pull the harness through the slot in the seat’s
backrest and fabric cover. Thread the harness strap back through the desired slot on the seat’s backrest.
Re-thread the harness strap back onto the harness connector at the back of the seat. Repeat the same
process for the other harness strap (make sure both of the straps go through the slots at the same
height).
DO NOT USE THE UPPER SLOTS ON THE BACKREST. THESE ARE FOR THE SEAT BELT LOCK ONLY.