phil&teds columbus - Manual (Page 7)

PRESS
PRESS
Step1. Slot the two metal sections of the buckle connectors together.
Step2. Insert the two buckle connectors into the slot at the top of the buckle until
you hear “click” .
Step3. Always check the harness is correctly locked by pulling the shoulder straps
upwards.
To release the harness, press the red button on the buckle downwards.
Pull the shoulder straps upwards to remove the
slack from the lap sections of the harness then pull
the adjuster strap until the harness is fully tightened.
The harness should be adjusted as tightly as
possible without causing discomfort to your child.
Ensure that the lap strap portion of the harness is
located as low as possible towards the thighs-not
around the tummy.
A loose harness can be dangerous. Check the
harness adjustment and tighten each time the child
is placed in the seat.
The harness is slackened by pressing the lever
(under the seat cover) on the front of the seat.
Press marked “Press” on the fabric cover while
you grip the two shoulder straps with your other
hand. Pull the shoulder straps towards you to loosen
the harness.
Take care when you adjust the shoulder straps that
you do not trap the harness adjuster straps as you
press the lever down.
TIGHTENING THE HARNESS
SLACKENING THE HARNESS
FASTENING THE SAFETY SEAT BUCKLE
STEP.1
5
STEP.2 STEP.3