2 refitting the 5-point harness system and cover – phil&teds evolution User Manual

Page 21

Care Instructions /20

5.2 Refitting the 5-point harness

system and cover

•

After washing, place the cover on the shell

(5-D).

•

Loosen the bottom part of the cover and pull

the belt clip through the belt clip slot (5-E).

•

Then pull the buckle clip through the buckle

clip slot (5-F).

•

Thread the belts through the belt pads, head

pillow, the cover and the shell (5-G).

•

Attach the shoulder belts to the belt yoke

and make sure that the red stitching on the

belt ends and the yoke are facing the shell,

(if this is not the case, your belts are twisted,

so untwist) then close the belt guard door.

(3-F to 3-H).

•

Close the buckle (5-H) then fasten the cover

all around, also using the pins. Check the fit!