phil&teds quest - Manual (Page 10)

Instructions
1. Open the harness buckle (press the red release button).
2. Place your child into the child seat. Put the shoulder
straps over the child’s shoulders.
3. Slot together the two plastic sections of the buckle
connectors.
4. Slide the two connectors into the slot in the top of the
buckle until they “click” into place.
Caution!
• Ensure the two buckle tongues are together and
engaged in the harness buckle with an audible
CLICK!CLICK!
• Always check that the harness is correctly engaged by
pulling above and below the buckle and ensuring that
the connectors do not come free from the harness.
Caution!
• Do not twist or interchange the shoulder straps.
• Tighten the straps until they are in contact with the
child's body.
• The hip belt must lie as low as possible over the child's
hips.
• The straps of the child safety seat must be
close to the body without constricting the child.
• The shoulder straps must be adjusted correctly.
• The straps must not be twisted.
• The tongue from the adult seatbelt must be correctly
engaged in its corresponding seat belt buckle.