phil&teds sport v2 - Manual (Page 8)

english brakes
g stand behind buggy and with one foot push
brake down to activate; lift to deactivate.
note always apply brakes when parking your
buggy. apply brake before loading children.
handle
h stand behind buggy, press in both grey
buttons, rotate handle into desired position.
hood
i Insert crimped wire ends into eyelets on
both sides of buggy frame.
j rotate hood back and slide rear sunhood
wires into fabric channels on top of buggy
frame as shown.
k rotate hood forward and attach sunhood
snaps to buggy frame then pull hood eyelets
over hooks on top of buggy frame.
harness
l unclip buckles on breastplate and place
baby in buggy. set upper strap height to
fit snugly over baby’s shoulders. breast-
plate should fit snugly on baby’s chest.
(you should be able to fit 2 average
sized fingers between straps and baby).
ups ` downs
there are 4 seat positions: upright, heads up,
sleepy and lie-flat. adjust as required using
seat adjustment clips and zips at rear of
main seat.
m upright: all 4 clips and both zips are done up.
n heads up: all 4 clips are done up but both
zips are undone.
o sleepy: all 4 clips are undone but both zips
are done up.
p lie-flat: all 4 clips and both zips are undone.
q to return seat to upright position:
invert base, reattach clips and do zips up.
plastic back flap
r clear plastic back flap can be attached
to back of buggy to help protect your child
from poor weather. attach using velcro and
as shown. back flap can be rolled up and
held at top using velcro under hood.
warning: never allow plastic to fall over child.
baby ` toddler buggy
to use baby ` toddler position requires
purchase of a phil`teds double kit accessory.
s double kit comes with hinges attached,
push in nib springs and insert into buggy,
once pull bar is removed.
3