phil&teds peanut - Manual (Page 4)

peanut
peanut instructions
Use only for children weighing no more than
9kg/19.8lbs
Follow these simple steps and you’ll be ready
for some home & away rest assurance in
no time!
bits & bobs
Red numbers below refer to peanut parts
indicated on the inside back flap of this guide.
1. Head end leg
2. Foot end leg
3. Handles (x2)
4. Aluminium frame and fabric wall
5. Fabric wall cord
6. Plastic base
7. Plastic base brackets (x4)
8. Harness fixing points
9. Mattress
10. Cover
11. Vibe latch hooks
12. Vibe latch lever
13. Classic/Sport/Dash/Hammerhead frame
grips
IMPORTANT – READ
THE INSTRUCTIONS
CAREFULLY BEFORE
USE AND KEEP THEM
FOR FUTURE REFERENCE.
14. Classic/Sport/Dash/Hammerhead locking
arms (left & right hand)
15. Nutshell
16. Head end
17. Foot end
safe & sound
We’ve attained the following safety standards:
• EN 1466:2004
• EN1888:2005
• ASNZS 2088:2000
• ASTM F833-07a
• ASTM F2194-07a
getting to grips
Letters in red refer to line drawings on the inside
front cover.
a Carefully remove the peanut and its
component parts from the packaging.
Remove the cover and mattress from the
aluminium frame and fabric wall and check
the plastic base is correctly positioned;
making sure the curved edges face upwards.
b Standing side-on to your peanut rotate both
legs downwards towards the centre of the
peanut, as shown. Push the plastic base
down into the fabric wall.
c Turn the peanut upside down on a flat surface
keeping hold of the plastic base as you turn
it over. Locate the plastic base brackets, two
at each end of the base. Note that there are
2