Philips BG2020-31 - Manual (Page 7)

Cleaning
I The Groomer should be cleaned after each use.
k Always switch Groomer OFF and remove cord
from charging stand and charging plug from
outlet before cleaning.
k Never clean, remove or replace shaving head
assembly while motor is on.
k Do not apply pressure to shaving head. Do not
touch foil with hard objects as this may dent or
damage foil or cutters. If damage occurs, replace
damaged parts.
k Do not use Groomer if foil, cutters or trimmers
are damaged or broken as injury may occur.
k Only use the cleaning brush supplied. Any other
brush may cause damage.
n Always switch Groomer OFF, remove the
charging plug from outlet and remove cord
from charging stand before cleaning.
Bif a trimming comb is attached to the
Groomer, remove it by pulling it off the
appliance.
B Remove the shaving foil head by pulling it off
the appliance (Fig. 8).
Hold the shaving head by the plastic housing only.
D Brush the hairs off the shaving foil and cutter
block. Make sure to also brush away any
hairs collected under the trimmers (Fig. 9).
H Reattach the shaving foil head by snapping it
back onto the Groomer (Fig. 10). You will hear
a “click".
□ Rinse the Groomer under warm or cool
running tap water to rinse away any
remaining shaving/trimming debris (Fig. 11).
B
After rinsing, gently shake excess water from
Groomer.Wipe the Groomer body dry with
a clean towel or cloth.
k Do not use a towel or cloth to dry shaving
foil or cutters as this may cause damage;
allow to air dry.
k Never clean the Groomer with harsh chemicals
as they can damage the Groomer.