Chicco Car Seat - Manual (Page 17)

32 33
1 .Position Base.in.forward.facing.
vehicle.seat.with.Recline.Foot.
against.seat.back.
2 .Adjust Base Angle.by.pushing.
Recline.Buttons.while.lifting.Base...
Angle.is.correct.when.Bubble.is.
between.arrows.
.
Vehicle must be on a level surface for
the Bubble to indicate correctly.
3 .Route Vehicle Belt.through.
openings.in.Base.and.buckle.
the.vehicle.belt..(Do.not.put.the.
shoulder.belt.in.locked.mode.)
4 .Tighten Vehicle Belt.while.
pushing.Base.firmly.into.vehicle.
seat.
.
5 .Secure Vehicle Shoulder Belt.
firmly.under.Shoulder.Belt.Lockoff,.
while.keeping.tension.on.Belt..Only.
use.the.lockoff.on.the.opposite.
side.of.the.buckle.
...
1
INSTALLATION USING VEHICLE BELT
LATCH or Vehicle Belt? This Child Restraint can
be safely installed using Vehicle Belts or LATCH.
Use the method that results in the MOST
SECURE installation in your vehicle.
2
3
4
6 .CHECK Installation:
. a .Belts.MUST.be.TIGHT.
. b .Base.MUST.be.STABLE.
. c .Bubble.MUST.be
. . between.arrows.
. d .Belts.&.Buckles.MUST.NOT..
. . INTERFERE.with.attachment..
. . of.Carrier.to.Base.
7 .Attach Carrier To Base.after.
properly.securing.child.in.Carrier.
.
.
Uninstalling Base:
Remove.Carrier.from.Base,.
unbuckle.Vehicle.Belt,.and.remove.
Base.from.vehicle. 7
NEVER travel with Child Restraint unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
INSTALLATION USING VEHICLE BELT
5
If using Vehicle Lap Belt only
(no Shoulder Belt), make sure
that Lap Belt is LOCKED, and
that free end of Lap Belt is
neatly stored so it DOES NOT
INTERFERE with attachment
of Carrier to Base.
6
ALWAYS lift up on Carrier
to verify it is properly attached
to the Base.