Philips BG2030-60 - Manual (Page 9)

Shaving Attachment
D
Pull the shaving foil unit out of ^e shaving
attachment (Fig. 14).
Noie:The shoving foil unit is very ddkote. Handle
it carefully. Replace the shoving foH unit ifit h darth
aged.
□ Rinse the shaving foil unit with lukewarm
water. Make sure that you also remove any
hairs that have collected under the trimmers.
Do not clean the shaving foil unit with the
cleaning brush, as this _may. cause damage.
a
Remove hairs from the inside of the
shaving attachment with the cleaning
brush and/or with lukewarm water (Fig. 15).
a
After cleaning, snap the shaving foil unit
back into the shaving attachment ('click')
(Fig. 16).
Replacing the Shaving Foil Head
I If the shaving foil and cutters are worn or
damaged, do not continue using the Groomer.
Replace the shaving foil and cutters immediately.
I It is recommended that you replace your
shaving foil and cutters once a year.
IA worn or damaged shaving foil or cutters
should only be replaced with an original Philips
Norelco shaving foil, model BG20(X). which is
available on the Philips Norelco website.
www.phiiips.com/norelco or call
1-800-243-3050 for assistance.
t The foil is a precision part. Handle with care.
il Always switch Groomer OFF and remove
Groomer from the charging stand before
replacing shaving foils.
□ Remove the shaving foil head by pulling it off
the appliance (Fig. 15).
□ Place the new shaving foil head on the
Groomer by snapping it into place (Fig. 17).
You will hear a “click”.
After replacing the shaving foil head, check that
the having head is firmly attached before using
Groomer
Th|? Grwmcr has no other parts,
For assistance call I -800-243-3050.