beautypg.com

Trimming nose hair – Philips NT9130-40 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Inserting the Battery

I Make sure your hands and trimmer are

dry when inserting the battery.

This appliance requires 1 “AA” 1.5 volt

alkaline battery.

A new battery has an operating time of up to

2 hours.

Keep the appliance at a temperature between

40°F and 100°F.

Do not keep the appliance in direct sunlight.

D

Make sure trimmer is in the Off (0) position.

Q Turn the battery compartment to the left

so that the setting indicator points to the
‘open’ indicator (fig. 1).

Q Remove the battery compartment by pulling

it downwards (fig. 2).

D Put the battery in the battery compartment as

shown making sure the (+) and (-) markings
on the end of the battery match the (+) and (-)
markings on the battery compartment (fig. 3).

Q If the battery is not inserted properly, the

appliance will not work.

Q Slide the battery compartment cover back

onto the trimmer.

Q Turn the battery compartment to the right

so that the setting indicator points to the
‘Off’ (0) indicator (fig. 4).

If the appliance will not be used on a regular

basis, remove the battery when storing the

appliance to prevent possible damage due to

chemical leakage.

If the battery does leak, remove carefully.

Never allow your bare skin to come into

contact with the leaking fluid.

Using the Trimmer

You can use the trimmer to trim nose hair, ear

hair or neck hair.

Use the eyebrow combs to trim your

eyebrows to a uniform hair length.

Use the precision trimmer head to shape

and maintain beard, sideburns and neck hair.

If using the precision head trimmer for the

the first time, attach the detailer comb to

prevent trimming hairs too short.

Test trimmer on a small area of your arm or

leg. If any sensitivity occurs, discontinue using
immediately. Do not use trimmer on sensitive
or irritated skin.

Turn trimmer off before putting on or taking

off attachments or cleaning.

Trimming Nose Hair

n Make sure nasal passages are clean before

trimming.

Q Remove the Protective Cap by pulling it off

the trimmer (fig. 5).

B Turn trimmer ON by turning the battery

compartment to the right until the setting

indicator points to the ‘ I ’ (on) indicator
(fig-6).

□ Carefully insert the trimmer tip into one

nostril.

CAUTION: DO NOT INSERT THE TIP

MORE THAN %"/6mm INTO NOSTRIL.

B Slowly move the trimmer tip in and out of

each nostril to remove unwanted hair (fig. 7).

B For best results, make sure the side of the tip

is held firmly against the skin. This will
reduce the tickling effect that can occur.

Q Turn trimmer OFF by turning the battery

compartment to the left until the setting

indicator points to the ’0’ (off) indicator
(fig-8).

lil Clean trimmer immediately after using.