Talkswitch 24-CA - Manual (Page 36)

2 4 T A L K S W I T C H US E R G U I D E • N O R T H A M E R I CA
Figure 25: Examples of three-digit identifiers
1.9.5 Keep track of the lines and extensions
To keep track of the extensions and the lines connected to each unit, label
each unit with its unit ID. It simplifies matters when you need to add or
remove extensions and lines.
If the units are located in a room away from the extensions and you need to
identify the units, the View System Information utility in the configuration
software allows you to identify each unit as follows:
1. Open the TalkSwitch configuration software.
2. Click the View System Information link below the TalkSwitch image. See
Figure 26.
3. Select the Unit ID to verify.
4. Click the Identify button and observe the flashing LEDs. The lights stop
flashing when you click the Close button or when 5 minutes have
elapsed.
Unit ID 1 Unit ID 2 Unit ID 3 Unit ID 4
Local analog
or IP
extensions 111–118 121–128 131–138 141–148
Remote
extensions 210-219 220-229 230-239 240-249
Local
mailboxes 111-118 121-128 131-138 141-148
Remote
mailboxes 210-219 220-229 230-239 240-249
General
mailboxes 410-419 420-429 430-439 440-449