Talkswitch 24-CA - Manual (Page 115)

T A L K S W I T C H C O N F I G U R A T I O N 1 0 3
Accessing and using prompted call back from a telephone
1. Dial your office telephone number.
2. At the auto attendant, dial 6 to access the call back settings.
3. Follow the prompts.
a) Enter the telephone number where you would like TalkSwitch to call
you.
b) Record an announced message if required. Call back is activated right
after you initiate prompted call back and hang up. A small initial
long-distance charge is incurred at your current location when you
activate prompted call back.
Press on an analog phone or 55 on a IP set to enter
command mode. Enter the password if required.
Enter the command as listed below.
2.5.3 Call bridge
Call bridge allows you to use the TalkSwitch phone lines to make outbound
calls or transfers to local and remote office extensions. It gives you access to
your office-based long-distance savings plan from anywhere around the
world. You will first need to call into the unit from an outside phone
number.
When you access prompted call back from out of the office, you may
change this number before initiating the call back. The benefit of
prompted call back is that you do not need to set the number before you
leave the office.
To record a message:
65
To play the message:
75
The call back number shown is always the last number the unit dials in
the last prompted call back session.
# *
#
#