Chauvet ABYSS JR. CH-222 - Manual (Page 8)

Appendix
CH-222 User Manual 8 2005-07-22/17:40
General Troubleshooting
Applies to
Symptom Solution(s)
Lights
Foggers
& Snow Controllers
Dimmers
& Chaser
Auto shut off Check fan thermal switch reset

Beam is very dim or not
bright Clean optical system or replace lamp
Check 220/110v switch for proper setting

Breaker/Fuse keeps
blowing Check total load placed on device 
Chase is too slow Check users manual for speed adjustment
  
Device has no power Check for power on Mains.
Check device
’s
fuse. (internal and/or external)
  
Fixture is on but there
is no movement to the
audio Make sure you have the correct audio mode on the control
switches. If audio provided via
¼” jack, make sure a live
audio signal exists
Adjust sound sensitivity knob
  
Fluid indicator not
working The filter tip on the end of the tube inserted into the fluid
container must float freely in order to measure correctly,
check to see if perhaps it is stuck

Fogger or Snow output
has dropped Clean with distilled water and vinegar
Replace hose

Lamps cuts off
sporadically Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.

Light will not come on
after power failure Some discharge lamps require a cooling off period before
the electronics in the fixture can kick start it again, wait 5 to
10 minutes before powering up

Motor movements are
jerky or jumpy Possible bad motor driver or sensors
Check polarity switch on controller
 
Moves slow Check 220/110v switch for proper setting

No flash Re-install bulb, may have shifted in shipping

No fog Check fluid tank if empty
Make sure green light is on (for power)

No light output Check slip ring & brushes for contact
Install bulb
Call service technician

Relay will not work Check reset switch
Check cable connections

Remote does not work Make sure connector is firmly connected to device
 
Unit wobbles when
rotating Check for damages possibly incurred during shipping 