CFM Corporation A125 - Manual (Page 21)

21
Gas Fireplace Insert
10002964
5. Remove the two screws that hold the top brass trim.
6. Install the two brackets to the studs in the bottom of
the top channel. Use the nuts supplied with top trim
channel.
A flat louvre kit OR a bay window kit need
to be chosen to complete the installation.
4
2
3 4
1
6 6
5
FP1289
RHE
trim parts
2/03
RHE25SSP & HE25LP Replacement Parts
FP1289
CFM Corporation reserves the right to make changes in design,
materials, specifications, prices and discontinue colors and products
at any time, without notice.
IMPORTANT: Only trim panel assemblies approved
by CFM Corporation can be used on these prod-
ucts.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information:
Model and serial number, part description with finish
and part number.
(1) LP trim to be used with SSP trim.
SSP trim dimensions are for openings smaller than 26¹⁄₂" H x
38" W (673mm x 965mm).
LP trim dimensions are for openings smaller than 29" H x 41"
W (736mm x 1040mm).
Key Description RHE25SSP HE25LP (1)
1 Trim Frame Black 10001939 -
2 Trim Top Deflector 55099 -
3 Trim Top Channel (1) 55077 -
4 Trim Side Channel 55096 -
5 Trim Top Channel - 55097
6 Trim Side Channel - 55080
7 Fasteners Package
(Not Shown) 54618 57633
2. Install top and bottom brass trim by using the short-
est black screw. (Fig. 26 & 27)
3. Install bottom decorative plate by simply sliding it
under the unit floor. No fastening is required for this
installation. (Fig. 28) Be sure to remove protective
cover.
4. Install the bottom louvre assembly by fastening the
hinges with four screws to the pre-punched holes in
the cabinet.
5. Re-install the front glass.
6. Install the top louvre by using the hooks to hang it in
place.
A2 HE25FP Trim
For use with A125
HE25FP Flat face louvres with polished window
brass trim
Trim Assembly
1. Remove the front glass (see "Glass Frame Removal"
section).
FP1290
RHEDV
frame mounting
glass
2/03
Trim Top
Trim Bottom
Glass Frame
Screws
FP1290
Fig. 26 Install top and bottom brass trim.
FP1291
RHEDV
glass trim top
2/03
Louvre
NOTE: Position
brass trim top as
shown (small end
up) to prevent heat
discoloration.
Glass Frame
FP1291
Fig. 27 Position brass trim to with small end up.
FP1292
bottom channel
2/03
Bottom
Decorative
Plate
FP1292
Fig. 28 Slide bottom decorative plate under unit floor.