Coleman 9992-449 - Manual (Page 3)

Tools Needed:
Phillips head screwdriver
1/4" nut driver *
9/16" wrench
Adjustable wrench
Fig 4
Fig 1
Fig 2
Fig 3
Rear Heat Shield
Screws
Heat Tents
Screws
* socket set with extension can also be used.
Be sure gas supply is off, the knobs are in the off
position and the grill is cool.
1. Remove cooking grates and heat tents.
(See Fig. 1).
2. Remove the screws holding the rear heat shield
in place. Lift out rear heat shield and set
aside (Fig. 2).
3. Remove the two screws holding each igniter in
place (Fig. 3).
4. Lay igniters on floor of grill (Fig. 4).
Liquid Propane Gas Conversion Instructions
3