Concord Camera Eye Q Duo 1.3 Mega Pixels Camera - Manual (Page 4)

LOADING THE BATTERIES
The Concord Eye-Q Duo LCD uses 2 LR6 AA batteries.
To load the batteries:
1. Locate the battery door on the bottom of the camera.
2. Slide the button on the battery door toward the center of the camera.
(fig.1.1)
3. Lift the battery door to open.
4. Insert the batteries with the positive terminal toward the + sign, and the
negative terminal toward the - sign. (fig.1.2)
5. Close the battery door.
TURNING THE CAMERA ON AND OFF
When the camera is turned on, the camera ready LED on the back of the
camera blinks and the LCD displays the current settings.
1. Press the Power button.
2. The camera is ready for picture taking when the camera ready LED stops
blinking and LCD icons appear on the LCD. (fig.1.3)
3. To turn the camera off, press the Power button.
Note: To change this setting, please refer to the TV Mode section of the User’s Guide for further
instruction.
SETTING THE FLASH
1. In the FLASH menu, press or to choose
between Auto ( A ), Flash ( ), and Flash
Off ( ).
2. Press OK to select the flash mode and press
MENU to exit.
Flash Status Distance from subject
Auto ( A ) 8.5ft (2.5m)and 3.9ft (1.2m).
Flash ( ) 8.5ft (2.5m)and 3.9ft (1.2m).
Flash Off ( ) 3.9ft (1.2m) to infinity
Note: The flash may need time to recharge between photos. While it is charging the camera
ready LED blinks. When it stops blinking you are ready to take another picture. If the batteries
are low, the flash will not work. Insert fresh batteries.
2
fig.1.1
fig.1.2
fig.1.3
M o d o
C a l i d a d
F l a s h
W B
M E N Ú P R I N C
A u t o
F l a s h
F l a s h O f f
M a i n M e n u
F L A S H
Duo QS Guide (3L) 8/7/02 9:33 am Page 3