Philips QG3270-41 - Manual (Page 8)

Trimming your Beard & Moustache
with Beard & Moustache Comb
D
Put the trimmer on Groomer handle (fig. 14).
You will hear a ‘dick’.
u
Slide the beard & moustache comb into
the guiding grooves on both sides of the
handle and push until it‘clicks’ into place
(fig. 15).
Q Press the Hair Length Setting Selector (I)
and slide it to the desired setting (2) (fig. 16).
See Table 2 for settings.
I If you are trimming for the first time, start
by using the comb at the maximum trimming
length setting (23/32 in/18mm) to prevent
accidentally trimming hairs too short. As you
become familiar with the settings, adjust Hair
Length Setting Selector to desired trimming
length. Selector will "click” into position at each
setting.
D Switch the Groomer ON (fig. 8).
H To trim in the most effective way, move
the Groomer against the direction of hair
growth. Make sure the surface of the comb
always stays in contact with the skin.
NOTE: Since all hairs do not grow in the same
direction, you may want to try different trimming
directions (i.e.. upwards, downwards, or acrossl
Practice is best for optimum results.
► If a lot of hair has accumulated in the comb,
remove the comb and blow and/or shake the
hair out of the comb.You can also use the
cleaning brush provided to remove
hair from the comb area.
Table 2. Beard Trimmer
Remaining hair length
(mm)
Remaining hair length
(in.)
2mm 5/64 in
4mm 5/32 in
6mm 1/4 in
8mm 5/16 in
lOmm 13/32 in
12mm 15/32 in
Hmm 9/16 in
16mm 41/64 in
18mm 23/32 in
I REMEMBER: You must reset the hair length
selector back to your desired setting every time
you replace the comb on the appliance
I The remaining hair length corresponds with
the smallest distance between the cutting
blade and the spot where the comb is in contact
with the skin.