For use liimrat, Itiop – Philips DSS350S1 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FOR USE liiMrat.
peration
itiop^
'
i
2
м
М
м
\ H :
l
^
1
Switch on the speakers using the POWER
button.
-► The power indicator goes on.
2
Adjust the sound using the VOLUME, DBB,
and INCREDIBLE SURROUND controls.
Details on operation
• The volume controls on the satellite speakers
can only be used if the USB is connected and
supported by the operating system.
• If the USB is connected, the speakers will
switch to standby while the computer is
turned off. When the computer is switched
on, the speakers will switch on too.
• Legacy DOS games do not support USB.
Sounds can only be played via a soundcard
that is connected to the LINE IN jack of the
speakers.
The speakers only work with the supplied power
supply. Any others may damage the speakers.
Do not expose the speakers to excessive heat
(caused by heating equipment or direct sunlight).
To reduce the risk of fire or electric shock, do
not expose this appliance to rain or moisture. If
fluid spills into the speakers, disconnect any
connections immediately and let the speakers
dry before reusing them.
You may clean the speakers with a soft, slightly
dampened lint-free cloth. Do not use any
cleaning agents as they may have a corrosive
effect.
If the speakers do not react to operations,
disconnect them from the power supply. Wait a
few seconds before reconnecting them.
The typeplate is located on the bottom of
the speakers.
Use the following procedure if a soundcard is
installed on your Windows 98 system. This
should enable audio playback via the USB.
1
Choose the
Start
button in the task bar.
2
Point to
Settings
and choose
Control
Panel.
3
Double-click the
Multimedia
icon.
4
Select the
Audio
tab.
5
Under
Preferred device,
select
Philips
USB Audio Device.
6
Select the
Use only preferred device
check box on the bottom of the tab.
7
Choose the
OK
button.
Technical data
Power
2X15WRMSV1 kHz/2.7D/10%THD
FTC rated
2 X15 W /120-10.000 Hz/10 % THD
Frequency response........................ 60-20,000 Hz
Power input................................ 10.5V/1,600 mA
System.................................. two-way bass reflex
Driver...........................4" woofer and 2" tweeter
Dimensions..........................275 x 140 x 187 mm
Weight.................................................... 4.8 kg/set
"±1 dB
Subject to change without notice.