OmniSistem Beta 3 – TLB-101 - Manual (Page 6)

4
TLB-101
INSTALLATION GUIDANCE
0
1
2
3
4
5
TLB-101 three points (trigonometry) suspension
The flying system includes TLB-101 flying metal frame, front and back rigging parts and pins
Rear rigging part has been assembled onto cabinet to make the vertical angle
(between each unit) adjusting easier and convenient
TLB-101 flying frame is weld steel frame,
can hang up many TLB-101 speakers
The adjust angle between TLB-101
and flying frame grid is 5
The angle range between each speaker is 0 - 10
The angle between TLB-101 and TLA-101
can be adjusted at: 0 - 5 , t he
suspension hole is as drawing:
TLB-101 has four rubber feet on
one side of the enclosure, and it's
available for ground stacking
application. The feet can be
disassembled when it's for flying
avenues (please keep the screws
into the screws hole as it was).
Note: Please ensure the angles adjust panel hole
should be matched with relevant hole with degree
marks.