OmniSistem PR XL 700 Wash - Manual (Page 12)

12/20
188-195 Stop in current position
196-201
Rainbow reverse rotation speed
1(slowest)
202-207 Rainbow reverse rotation speed 2
208-213 Rainbow reverse rotation speed 3
214-219 Rainbow reverse rotation speed 4
220-225 Rainbow reverse rotation speed 5
226-231 Rainbow reverse rotation speed 6
232-237 Rainbow reverse rotation speed 7
238-243 Rainbow reverse rotation speed 8
244-249 Rainbow reverse rotation speed 9
250-255 Rainbow reverse rotation speed 10
10 10 15 Zoom 000-255 Linear adjust from 15° to 42°
16 Zoom Fine 000-255 Zoom in 16 precision
11 11 17 Narrow Angle 000-255
Open the inside Fresnel lens, change
beam angle to 10°
12 12 18 Pan 000-255 Pan rotation 450°
13 19 Pan Fine 000-255 Pan rotation in 16 precision
13 14 20 Tilt 000-255 Tilt rotation 270°
15 21 Tilt Fine 000-255 Tilt rotation in 16 precision
16 22 Pan & Tilt
speed
000-255 Pan&Tilt speed from fast to slow
000-048 Reserved
049-080 Reset
081-112 Reserved
113-144
Lamp off ( stop in DMX value for 10 s)
145-168 Reserved
169-200
Lamp power reduced to 50%
201-223 Reserved
14 17 23 Control
224-255 Lamp on (See remark below)
Remark:
If you intend to turn on/off the lamp via the last channel of the controller, don’t attempt to push the channel to value
224-255 immediately after turning it off, or push the slide bar to value 224-255 to wait it cooling. Under these 2
circumstances, the lamp can not be turned on. The right operation is: turn it off---cool down---push the slide bar to turn it
on.