OmniSistem PR XL 1200 - Manual (Page 16)

16/26
248-255 Rotation speed 8 (fastest)
000-020 White
17 19 25 Effect Wheel
021-255 Wheel full into beam gradually
000-125 Rotation speed from fast to slow
126-141 Stop in current position
18 20 26 Effect Wheel
Rotation
142-255
Reverse rotation speed from slow to
fast
19 21 27 Focus 000-255 Linearly focusing
28 Focus Fine 000-255 Focus in 16 precision
20 22 29 Zoom 000-255 From large to small
30 Zoom Fine 000-255 Zoom in 16 precision
21 23 31 Beam Angle
Lens
000-255 Wide Beam angle lens insert
22 24 32 Pan 000-255 Pan rotation 450°
25 33 Pan Fine 000-255 Pan rotation in 16 precision
23 26 34 Tilt 000-255 Tilt rotation 270°
27 35 Tilt Fine 000-255 Tilt rotation in 16 precision
28 36 Pan & Tilt
speed
000-255 Pan&Tilt speed from fast to slow
000-048 Reserved
049-080 Reset
081-112 Reserved
113-144
Lamp off ( stop in DMX value for 10 s)
145-168 Reserved
169-200
Lamp power reduced to 50%
201-223 Reserved
24 29 37 Control
224-255 Lamp on (See remark below)
Remark:
If you intend to turn on/off the lamp via the last channel of the controller, don’t attempt to push the channel to value
224-255 immediately after turning it off, or push the slide bar to value 224-255 to wait it cooling. Under these 2
circumstances, the lamp can not be turned on. The right operation is: turn it off---cool down---push the slide bar to turn it
on.