OmniSistem Thin Par Pro 64 - Manual (Page 2)

INFORMATION SUBJECT TO CHANGE WITHOUT NOTICE. INFORMATION SUBJECT TO CHANGE WITHOUT NOTICE.
OmniSistem, 2012 OmniSistem, 2012
INCLUDED IN BOX
 1 x OmniSistem THIN PAR PRO 64
 YOKE, KNOBS, SPACERS
 POWER CORD
 USER MANUAL
UNPACKING INSTRUCTIONS
Upon receiving the unit, unpack carton and verify that all parts have
been received in good condition. If there is an sign of damage to the
carton or unit due to shipping or mishandling, notify the shipper
immediately. Keep original packing materials in the event the unit
must be returned for any reason or recycle it when possible. All
fixtures must be returned in their original packaging.
In the unlikely even an accessory is missing that should have been
received with the unit or if something is wrong with the unit, notify
OmniSistem immediately WITHIN 3 DAYS of receiving the item. If
notification is not received within 3 days, unit is considered to have
been received with all components and without damage.
CONTACT US
6403 SOUTH 208TH STREET
KENT, WA 98032
TEL: 253-395-9500
FAX: 253-395-9494
WWW.OMNISISTEM.COM
OFFICE HOURS: MONDAY – FRIDAY 8AM - 5PM PST
TECHNICAL SUPPORT: M - F 9AM - 4PM PST
NOTE: INFORMATION ON RETURNING YOUR PRODUCT FOR
REPAIR IS ON THE WARRANTY PAGE.
QUICK SPECS
SAFETY INFORMATION
 This unit is intended for indoor use only.
 Ensure the power source is of the correct voltage for this fixture. Connect
power through a direct switch circuit, NOT a dimmer or variable circuit
source.
 Do not install or operate the device in harmful environment conditions. (i.e.
extreme heat, cold, moisture or dust)
 If the unit has been exposed to extreme environmental conditions or drastic
temperature fluctuations, ensure the unit is returned to room temperature
before operating.
 Do not block fan or ventilation slots while operating unit.
 Do not aim smoke or bubble effects near unit.
 Do not operate the unit during thunderstorms.
 Disconnect power prior to replacing fuse, servicing or cleaning unit.
 Do not use solvents or abrasive cleaners to clean the unit. Use a damp cloth
only.
 Modification(s) to the device or power cord will result in termination of the
dealer/manufacturer’s warranty.
 Use safety cable for added security when installing the unit by the hanging
bracket.
 Avoid direct eye contact with the light source.
 Do not connect this unit to a dimmer pack.
 Do not leave unit unattended while operating for extended periods of time or
overnight.
POWER: AC 100-240v 60Hz
POWER CONSUMPTION: 25W
LED POWER:
10mm
LED COUNT: 144 LEDs (RGBA)
CONTROL:
DMX-512 (7 CHANNELS)
SOUND ACTIVE (AUTO, STROBE)
STAND ALONE (AUTO, STROBE)
MASTER/SLAVE (SOUND ACTIVE,
AUTO)
DIMENSIONS:
8 1/2 ” x 8 1/2” x 2 1/2” (w/o yoke)
10 1/2" x 10 1/2" x 2 1/2" (w/ yoke)
WEIGHT: 6 LBS