Cadillac 2007 DTS - Manual (Page 388)

9. Connect the other end of the negative (
−
)
cable to the negative (
−
) terminal location
on the vehicle with the dead battery.
Your vehicle has a remote negative (
−
)
terminal marked GND (
−
).
10. Now start the vehicle with the good battery
and run the engine for a while.
11. Try to start the vehicle that had the dead
battery. If it will not start after a few tries,
it probably needs service.
Notice: If the jumper cables are connected
or removed in the wrong order, electrical
shorting may occur and damage the vehicle.
The repairs would not be covered by your
warranty. Always connect and remove
the jumper cables in the correct order, making
sure that the cables do not touch each other
or other metal.
A. Heavy, Unpainted Metal Engine Part or
Remote Negative (
−
) Terminal (GND)
B. Good Battery or Remote Positive (+) and
Remote Negative (
−
) Terminals
C. Dead Battery or Remote Positive (+) Terminal
To disconnect the jumper cables from both
vehicles, do the following:
1. Disconnect the black negative (
−
) cable from
the vehicle that had the dead battery.
2. Disconnect the black negative (
−
) cable from
the vehicle with the good battery.
Jumper Cable Removal
388