NOYAFA NF-300 - Manual (Page 8)

11
Test result 5: BNC cable length test
If to insert one end of the BNC cable to be tested into “BNC” port of the main
tester, the other end is an open circuit, and then select length test, and then
press “ENTER” key to perform length test with the equipment, the following
interface will be shown:
It indicates that length of BNC cable is 10.1m. At this time, press any key to
return to the main menu, and then press “ENTER” key for re-test.
1 Open 1 0.1m
2 Open 1 0.1m
12
Scanning ...
c. Cable tracing test:
After powering on the main tester and entering main test menu, press “UP”,
“DOWN” key to move “ ” cursor to cable scan, and then press“ENTER”
key to find the line. The following interface will be shown:
Connect the cable to be found with the corresponding RJ45(Scan) port
, (RJ11,USB or BNC). Take network line finding as an example:
connect the network cable to be found with RJ45 port, move “ ” cursor to
cable scan, and press “ENTER” key to perform line finding test as shown in
the figure below:
of the
emitter
Your excellent helper in cable test! Your excellent helper in cable test!